Make sure you are running the batch files as Administrator.Īfter following the above-mentioned steps, you should have a working Group Policy Editor in Windows 10 Home edition. Now run x86.bat if you are running 32-bit Operating System and 圆4.bat if you are running 64-bit Windows 10.
This should replace two files x86.bat and 圆4.bat. Download the following zip file and unzip it to C:\Windows\Temp\gpedit\.Go to C:\Windows\Temp\gpedit\ folder and make sure it exists.If you are getting an “MMC cannot create a snap-in” error message while starting gpedit.msc, you may follow the steps below for a solution: Solving common problems with running gpedit.msc This will ensure you run the editor from the Run dialog. “ GroupPolicy“, “ GroupPolicyUsers” and gpedit.msc. Copy the following folders and files from C:\Windows\SysWOW64 to C:\Windows\System32.Follow the steps below after running the installer: However, if you have Windows 64-bit (圆4) then you will need some extra steps after running the installer. If you have a 32-bit Windows (x86) then the setup should be installed smoothly without any problems, and you should be able to access the Group Policy Editor through the Microsoft Management Console by going to Run –> gpedit.msc. This is a simple setup file which when run will install and configure the Group Policy Editor in your Windows Home system. You may download it from the below-mentioned download link.ĭownload GPEdit.msc Installer (854.7 KiB, 205,640 hits) Since the Group Policy Editor is not included in Windows 10 by default, we will need to download the editor first. Enable Group Policy Editor in Windows 10 Home using GPEdit Installer
0 kommentar(er)
